|
My 3c589 on a Hitachi Vision Book locks up under heavy load.
The 3c589 works with windows but locks up as a Samba or as a FTP server. Big time collisions. You wrote, "Symptoms of timing problems can include card recognition problems, lock-ups under heavy loads, high error rates, or poor device performance. Only certain host bridges have adjustable timing parameters: check the corresponding man page to see what options are available for your controller." Which man page would help me? I have looked at many. Below is some debug output from ifconfig and cardctl. Thanks, Brad Norman bnorman@skysurfer.com
===========================================
eth0 Link encap:Ethernet HWaddr 00:A0:24:60:17:06
inet addr:192.168.255.3 Bcast:192.168.255.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:331 errors:0 dropped:0 overruns:0 frame:0
TX packets:599 errors:1 dropped:0 overruns:0 carrier:47
collisions:120 txqueuelen:100
Interrupt:5 Base address:0x300
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:3924 Metric:1
RX packets:20 errors:0 dropped:0 overruns:0 frame:0
TX packets:20 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
===========================================
Socket 0:
no card
Socket 1:
5V 16-bit card present
Function 0: ready
===========================================
Socket 0:
not configured
Socket 1:
Vcc = 5.0, Vpp1 = 0.0, Vpp2 = 0.0
Interface type is memory and I/O
IRQ 5 is exclusive, level mode, enabled
Function 0:
Config register base = 0x10000
Option = 0x41, status = 0000
I/O window 1: 0x0300 to 0x030f, 16 bit
===========================================
Socket 0:
no product info available
Socket 1:
product info: "3Com Corporation", "3C589", "TP/BNC LAN Card Ver. 2a", "000002"
manfid: 0x0101, 0x0589
function: 6 (network)
|
Messages