Next-in-Thread Next Message

More More info, output of dmesg 

Forum: 3Com PCMCIA Ethernet Adapter Issues
Re: Question 3c589 on Hitachi Vision book locks up under heavy load. (Brad Norman)
Date: 2000, Jan 10
From: Brad Norman bnorman

This is the output of dmesg. I have been trying
different options such as mem_speed, cmd_time, &
cis_speed with no luck. In fact I am not sure if
I should put them in config.opts or rc.pcmcia.

Thanks for looking -


Linux version 2.2.6 (root@skybook) (gcc version #5 Fri Oct 29 14:12:32 EDT 1999
Detected 166656447 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 332.60 BogoMIPS
Memory: 95944k/98304k available (744k kernel code, 408k reserved, 1172k data, 36k init)
CPU: Intel Pentium MMX stepping 04
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
Intel Pentium with F0 0F bug - workaround enabled.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xeada0
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.9)
PCI_IDE: unknown IDE controller on PCI bus 00 device 91, VID=1283, DID=673a
PCI_IDE: not 100% native mode: will probe irqs later
PCI_IDE: simplex device: DMA disabled
ide0: PCI_IDE Bus-Master DMA disabled (BIOS)
PCI_IDE: simplex device: DMA disabled
ide1: PCI_IDE Bus-Master DMA disabled (BIOS)
hda: HITACHI_DK225A-21, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide1: probed IRQ 15 failed, using default.
hda: HITACHI_DK225A-21, 2061MB w/128kB Cache, CHS=523/128/63
hdc: ATAPI 10X CD-ROM drive, 128kB Cache
Uniform CDROM driver Revision: 2.54
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
Partition check:
 hda: hda1 hda2 hda3
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 36k freed
Adding Swap: 84668k swap-space (priority -1)
parport0: PC-style at 0x378 [SPP,PS2]
lp0: using parport0 (polling).
CSLIP: code copyright 1989 Regents of the University of California
PPP: version 2.3.3 (demand dialling)
PPP line discipline registered.
ad1848/cs4248 codec driver Copyright (C) by Hannu Savolainen 1993-1996
Found OPL3-SAx (YMF719)
YM3812 and OPL-3 driver Copyright (C) by Hannu Savolainen, Rob Hooft 1993-1996
Linux PCMCIA Card Services 3.0.9
  kernel build: 2.2.6 #20 Sat Apr 17 23:17:12 CDT 1999
  options: [pci] [cardbus]
Intel PCIC probe:
  Cirrus PD6832 PCI-to-CardBus at bus 0 slot 25, mem 0x08000000, 2 sockets
    host opts [0]: [ring] [0/7/4] [3/17/4] [no pci irq] [lat 128/176] [bus 32/34]
    host opts [1]: [ring] [0/7/4] [3/17/4] [no pci irq] [lat 128/176] [bus 35/37]
    ISA irqs (scanned) = 3,5 polling interval = 1000 ms
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x100-0x107 0x200-0x207 0x220-0x22f 0x400-0x40f 0x480-0x48f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
tty01 at 0x02f8 (irq = 3) is a 16550A
eth0: 3Com 3c589, port 0x300, irq 5, Auto port, hw_addr 00:A0:24:60:17:06
ISO 9660 Extensions: RRIP_1991A
lp0 out of paper
eth0: autodetected 10baseT

Next-in-Thread Next Message

Add Message to: "More info, output of dmesg"

Members Subscribe Admin Mode Show Frames Help for HyperNews at 1.10