|
This is the output of dmesg. I have been trying different options such as mem_speed, cmd_time, & cis_speed with no luck. In fact I am not sure if I should put them in config.opts or rc.pcmcia. Thanks for looking - Brad ====================================== Linux version 2.2.6 (root@skybook) (gcc version 2.7.2.3) #5 Fri Oct 29 14:12:32 EDT 1999 Detected 166656447 Hz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 332.60 BogoMIPS Memory: 95944k/98304k available (744k kernel code, 408k reserved, 1172k data, 36k init) CPU: Intel Pentium MMX stepping 04 Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. Intel Pentium with F0 0F bug - workaround enabled. POSIX conformance testing by UNIFIX PCI: PCI BIOS revision 2.10 entry at 0xeada0 PCI: Using configuration type 1 PCI: Probing PCI hardware Linux NET4.0 for Linux 2.2 Based upon Swansea University Computer Society NET3.039 NET4: Unix domain sockets 1.0 for Linux NET4.0. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP Starting kswapd v 1.5 Detected PS/2 Mouse Port. Serial driver version 4.27 with no serial options enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A apm: BIOS version 1.2 Flags 0x03 (Driver version 1.9) PCI_IDE: unknown IDE controller on PCI bus 00 device 91, VID=1283, DID=673a PCI_IDE: not 100% native mode: will probe irqs later PCI_IDE: simplex device: DMA disabled ide0: PCI_IDE Bus-Master DMA disabled (BIOS) PCI_IDE: simplex device: DMA disabled ide1: PCI_IDE Bus-Master DMA disabled (BIOS) hda: HITACHI_DK225A-21, ATA DISK drive hdc: TOSHIBA CD-ROM XM-1502B, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 ide1: probed IRQ 15 failed, using default. hda: HITACHI_DK225A-21, 2061MB w/128kB Cache, CHS=523/128/63 hdc: ATAPI 10X CD-ROM drive, 128kB Cache Uniform CDROM driver Revision: 2.54 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 Partition check: hda: hda1 hda2 hda3 VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 36k freed Adding Swap: 84668k swap-space (priority -1) parport0: PC-style at 0x378 [SPP,PS2] lp0: using parport0 (polling). CSLIP: code copyright 1989 Regents of the University of California PPP: version 2.3.3 (demand dialling) PPP line discipline registered. ad1848/cs4248 codec driver Copyright (C) by Hannu Savolainen 1993-1996 Found OPL3-SAx (YMF719) YM3812 and OPL-3 driver Copyright (C) by Hannu Savolainen, Rob Hooft 1993-1996 Linux PCMCIA Card Services 3.0.9 kernel build: 2.2.6 #20 Sat Apr 17 23:17:12 CDT 1999 options: [pci] [cardbus] Intel PCIC probe: Cirrus PD6832 PCI-to-CardBus at bus 0 slot 25, mem 0x08000000, 2 sockets host opts [0]: [ring] [0/7/4] [3/17/4] [no pci irq] [lat 128/176] [bus 32/34] host opts [1]: [ring] [0/7/4] [3/17/4] [no pci irq] [lat 128/176] [bus 35/37] ISA irqs (scanned) = 3,5 polling interval = 1000 ms cs: IO port probe 0x1000-0x17ff: clean. cs: IO port probe 0x0100-0x04ff: excluding 0x100-0x107 0x200-0x207 0x220-0x22f 0x400-0x40f 0x480-0x48f 0x4d0-0x4d7 cs: IO port probe 0x0a00-0x0aff: clean. cs: memory probe 0xa0000000-0xa0ffffff: clean. tty01 at 0x02f8 (irq = 3) is a 16550A eth0: 3Com 3c589, port 0x300, irq 5, Auto port, hw_addr 00:A0:24:60:17:06 ISO 9660 Extensions: RRIP_1991A lp0 out of paper eth0: autodetected 10baseT |