Thanks for the tip. The 3.1.10 driver did the trick. It's basically working now but not all the automatic startup stuff appears to be working. After reboot the card is bound to eth0 and all seems fine. However a ping to an adjacent node gets no response. However if I manually run '/etc/pcmcia/network stop eth0' followed by '/etc/pcmcia/network start eth0' then everything runs fine. Similarly if I eject the card and reinsert it I can no longer ping even though I hear two high beeps and again the eth0 interface appears to be correctly configured. Again manually starting and stopping the network as above resolves the problem. Any ideas?