I've tried it with another config. I get a different message. This is my /var/log/messages log when I insert the card.. Help? Nov 8 10:49:12 localhost kernel: vortex_detach(eth0) Nov 8 10:49:12 localhost cardmgr[764]: shutting down socket 0 Nov 8 10:49:12 localhost cardmgr[764]: executing: './network stop eth0' Nov 8 10:49:12 localhost cardmgr[764]: + usage: ifdown <device name> Nov 8 10:49:12 localhost cardmgr[764]: stop cmd exited with status 1 Nov 8 10:49:12 localhost cardmgr[764]: executing: 'rmmod 3c575_cb' Nov 8 10:49:12 localhost cardmgr[764]: executing: 'rmmod cb_enabler' Nov 8 10:49:22 localhost cardmgr[764]: initializing socket 0 Nov 8 10:49:22 localhost cardmgr[764]: socket 0: 3Com 3CCFE575B/3CXFE575B Fast EtherLink XL Nov 8 10:49:22 localhost cardmgr[764]: executing: 'insmod /lib/modules/2.2.12-20/pcmcia/cb_enabler.o' Nov 8 10:49:22 localhost cardmgr[764]: executing: 'insmod /lib/modules/2.2.12-20/pcmcia/3c575_cb.o' Nov 8 10:49:22 localhost kernel: 3c59x.c:v0.99L 5/28/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html Nov 8 10:49:22 localhost kernel: cs: cb_config(bus 32): vendor 0x10b7, device 0x5257 Nov 8 10:49:22 localhost kernel: fn 0 bar 1: io 0x200-0x27f Nov 8 10:49:22 localhost kernel: fn 0 bar 2: mem 0x60021000-0x6002107f Nov 8 10:49:22 localhost kernel: fn 0 bar 3: mem 0x60020000-0x6002007f Nov 8 10:49:22 localhost kernel: fn 0 rom: mem 0x60000000-0x6001ffff Nov 8 10:49:22 localhost kernel: vortex_attach(bus 32, function 0, device 5257) Nov 8 10:49:22 localhost kernel: eth0: 3Com 3c575 series CardBus (unknown version) at 0x200, 00:50:da:55:27:ac, IRQ 3 Nov 8 10:49:22 localhost kernel: 8K byte-wide RAM 5:3 Rx:Tx split, MII interface. Nov 8 10:49:22 localhost kernel: MII transceiver found at address 0, status 7809. Nov 8 10:49:22 localhost kernel: Enabling bus-master transmits and whole-frame receives. Nov 8 10:49:22 localhost cardmgr[764]: executing: './network start eth0' Nov 8 10:49:22 localhost cardmgr[764]: + usage: ifup <device name> Nov 8 10:49:22 localhost cardmgr[764]: start cmd exited with status 1 |
Messages