On Wed, 5 Jul 2000, David Hinds wrote:
Hej,
> > Jul 3 14:14:36 localhost cardmgr[489]: executing: 'modprobe cb_enabler'
> > Jul 3 14:14:36 localhost cardmgr[489]: + modprobe: Can't locate module cb_enabler
> For this you could edit /etc/pcmcia/config, find the 3c575_cb driver
> entry, and remove "cb_enabler" from the list of modules. Because it
> is built into your kernel.
Oki, I did it and it fonction correctly.
> > Jul 3 14:14:36 localhost kernel: PCI: No IRQ known for interrupt pin A
> > of device 02:00.0. Please try using pci=biosirq.
> I don't think I understand what this message means in this context
> (especially since your card seems to be configured ok, and was
> assigned irq 11)
The card works correctly, yes. But when I put the second one (the same
type) in the second PCMCIA slot, both of them will work on the same
interrupt. And I would like to avoid it.
---------------
Best regards
Pawel Wiatr
---------------
Don't worry if you have some problems with mathematics, mine are greater.
A. Einstein
---------------
|
Messages