Next-in-Thread Next Message

Question kernel panic unloading pcmcia tools 

Forum: PCMCIA driver development
Date: 2000, Mar 13
From: Pedro Alves capella

	Following my last post, I was able to compile the 
driver for my kingmax card. But I get some strange behaviour... When I load the pcmcia tools everything goes ok, 
the card is correctly detected. If I unload the pcmcia tools
(remove the modules) all goes well. If I set the ethernet
up with ifconfig (the main objective) all goes well, but  when
I unload the tools  (before or after setting ifconfig eth0
 down, doesn't matter), I always get a kernel panic...

 killing interrupt handler
 kernel panic: Attempted to kill the idle task
 In swapper task - not syncing

	Any suggestion on solving this?

				Pedro Alves

Next-in-Thread Next Message

Messages Inline: 1 All Outline: 1 2 All

1. None Report it to the vendor? by David Hinds, 2000, Mar 13
(_ More Untitled by Pedro Alves, 2000, Mar 22
(_ None That is not so strange by David Hinds, 2000, Mar 28

Add Message to: "kernel panic unloading pcmcia tools"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10