|
MANY thanks for your patient help. Summary: SCSI card recognized (cheers heard as far as the neighbors), 2 devices found, cannot seem to mount. There is a hard drive (formatted for windows2000, sorry), HPt20 drive, and a Yamaha 4x4x16 tape drive on the chain. It looks like the first two were detected, but could not figure out how to mount. Mounting this particular hard drive is not a big issue as today I am adding a second (new, empty) hard drive that will be dedicated to LINUX. When I can mount this, I would like to move the root (not boot) over to this hard drive--I have started to study your (coffee stained) HOWTO on this subject. At the very least, I will have a user directory on this external drive. I also tried cd /dev ./MAKEDEV st0 (should I have used sd--something?). Anyway, if there were a mouse with lots of LINUX experience in the corner of my room, I'm sure he would be selling tickets for a comedy show -- to witness my "experiences" (i.e. the response to "make all" was cc: not recognized! - to conserve disk space, I had not installed the C-compiler). fstab and the dmesg are reproduced below. [allens@allen allens]$ more /etc/fstab /dev/hda6 / ext2 defaults 1 1 /dev/hda3 /boot ext2 defaults 1 2 /dev/cdrom /mnt/cdrom iso9660 noauto,owner,ro 0 0 /dev/fd0 /mnt/floppy auto noauto,owner 0 0 none /proc proc defaults 0 0 none /dev/pts devpts gid=5,mode=620 0 0 /dev/hda5 swap swap defaults 0 0 [allens@allen allens]$ apa1480_attach(device 23:00.0) aic7xxx: <Adaptec PCMCIA SCSI controller> at PCI 35/0/0 aic7xxx: MMAPed I/O failed, reverting to Programmed I/O. (scsi0) <Adaptec PCMCIA SCSI controller> found at PCI 35/0/0 (scsi0) Narrow Channel, SCSI ID=7, 3/255 SCBs (scsi0) Downloading sequencer code... 423 instructions downloaded scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.28/3.2.4 <Adaptec PCMCIA SCSI controller> scsi : 1 host. Vendor: HP Model: T20 Rev: 3.00 Type: Sequential-Access ANSI SCSI revision: 02 (scsi0:0:5:0) Synchronous at 20.0 Mbyte/sec, offset 15. Vendor: IBM Model: DNES-309170W Rev: SAH0 Type: Direct-Access ANSI SCSI revision: 03 Detected scsi disk sda at scsi0, channel 0, id 5, lun 0 SCSI device sda: hdwr sector= 512 bytes. Sectors= 17916240 [8748 MB] [8.7 GB] sda: sda1 < sda5 > [allens@allen allens]$ mount sda1 mount: can't find sda1 in /etc/fstab or /etc/mtab [allens@allen allens]$ |
[ Edit This Forum ]