Next-in-Thread Next Message

None I think the driver side is all fine 

Forum: PCMCIA Installation and Configuration Issues
Re: Question Adaptec 1480 SCSI not quite working, other PCMCIA does (S. Allen)
Re: None Kernel compatibility issue: fixed in current drivers (David Hinds)
Re: Question Obvious that I am a newbie (S. Allen)
Re: None Wrong kernel source package (David Hinds)
Re: Ok SCSI working, now on to the next! Thanks (S. Allen)
Date: 2000, Jun 08
From: David Hinds <dhinds@pcmcia.sourceforge.org>

> cd /dev
> ./MAKEDEV st0 (should I have used sd--something?).

I'm pretty sure you already have appropriate st (tape) and sd (disk)
devices in /dev.

>   Vendor: HP Model: T20 Rev: 3.00
>   Type: Sequential-Access ANSI SCSI revision: 02
> (scsi0:0:5:0) Synchronous at 20.0 Mbyte/sec, offset 15.
>   Vendor: IBM Model: DNES-309170W Rev: SAH0
>   Type: Direct-Access ANSI SCSI revision: 03
> Detected scsi disk sda at scsi0, channel 0, id 5, lun 0
> SCSI device sda: hdwr sector= 512 bytes. Sectors= 17916240 [8748 MB]
> [8.7 GB]
>  sda: sda1 < sda5 >

This all looks good to me.  But I think maybe you don't have the SCSI
tape driver loaded?

> [ allens@allen allens]$ mount sda1
> mount: can't find sda1 in /etc/fstab or /etc/mtab

I'm not sure what you expected from this: "mount sda1" is not a well
formed mount command.  You can say "mount /dev/sda1 /mnt" (replace
/mnt with wherever you want to mount the device).

-- Dave

Next-in-Thread Next Message

Add Message to: "I think the driver side is all fine"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10