Next-in-Thread Next Message

None Maybe a very particular hardware fault

Re: Sad you're not kidding (toby cabot)
Date: 2000, Jun 20
From: David Hinds <dhinds@pcmcia.sourceforge.org>

> I scanned my messages log and found that the bridge mapping used to be
> 0x68000000 when things were working. So I tried setting the cb_mem_base
> to 0x68000000 but then get "Bad bridge mapping at 0x680000dc!".

This smells like a hardware failure.  The PCMCIA drivers are writing
0x68000000 to a register, and it is reading back as 0x680000dc.  Maybe
Windows works because it only writes to this register and never relies
on reading it back.

Just for kicks, you could try editing modules/i82365.c, find the line
that says:

 pci_readl(s, PCI_BASE_ADDRESS_0, &s->cb_phys);

and add right after that:

 s->cb_phys &= ~0x0fff;

-- Dave

Next-in-Thread Next Message

Select this message: Maybe a very particular hardware fault

Messages Inline: 1 All Outline: 1 2 All

1. Agree looks like you're right by toby cabot, 2000, Jun 21

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.


If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO


If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO


Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode No Frames New Base Frame Help for HyperNews at pcmcia-cs.sourceforge.net 1.10
[ Edit This Forum ]