Next-in-Thread Next Message

None You've got the source code, at least 

Forum: PCMCIA Installation and Configuration Issues
Re: Question cardinfo install (mike thomas)
Date: 2000, Jul 06
From: David Hinds <dhinds@pcmcia.sourceforge.org>

cardinfo is in the package you installed.  If a new one was not built
for you, then you don't have the "xforms" library installed.  Get the
0.88.1 RPM for that and install that, then re-configure and re-build
the PCMCIA tree (when you do "make config" for PCMCIA, at the end it
will tell you if xforms is installed).

cardinfo also hasn't changed in quite a long time, so an old one
should still be quite ok.

-- Dave

Next-in-Thread Next Message

Messages Inline: 1 All Outline: 1 2 All

1. Question Untitled by mike thomas, 2000, Jul 07
(_ None Re: Question: Untitled by David Hinds, 2000, Jul 07
(_ Ok Success by mike thomas, 2000, Jul 07

Add Message to: "You've got the source code, at least"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10