[ Next-in-Thread ]  [ Next Message ] 

You've got the source code, at least 

Forum: PCMCIA Installation and Configuration Issues
Re: Question: cardinfo install (mike thomas)
Date: 2000, Jul 06
From: David Hinds <dhinds@pcmcia.sourceforge.org> 

cardinfo is in the package you installed.  If a new one was not built
for you, then you don't have the "xforms" library installed.  Get the
0.88.1 RPM for that and install that, then re-configure and re-build
the PCMCIA tree (when you do "make config" for PCMCIA, at the end it
will tell you if xforms is installed).

cardinfo also hasn't changed in quite a long time, so an old one
should still be quite ok.

-- Dave

[ Next-in-Thread ]  [ Next Message ] 

Messages Inline: [ 1 ]  [ All ]  Outline: [ 1 ]  [ 3 ]  [ All ] 

1. Question: Untitled by mike thomas, 2000, Jul 07
(_ Re: Question: Untitled by David Hinds, 2000, Jul 07
(_ Ok: Success by mike thomas, 2000, Jul 07

[ Add Message ]  to: "You've got the source code, at least"

[ Members ]  [ Subscribe ]  [ Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ]