[ Next-in-Thread ]  [ Next Message ] 

Question: installing a Quatech spp-100 pcmcia card with 3.1.14 on kernel 2.3.99pre8 

Forum: PCMCIA Installation and Configuration Issues
Date: 2000, Jul 11
From: fletch

I have a Quatech spp-100 parallel port card that I would like to use with ppdev user-drivers, but cannot get the pcmcia card services to work correctly. I am using pcmcia-cs-3.1.14 and kernel 2.3.99-pre8 with parport, parport_pc,ppdev made as modules (they are shown in /lib/modules/2.3.99-pre8/misc as parport.o parport_pc.o, ppdev.o). When I attempt to start pcmcia services I receive a high beep followed by a low beep. The cardctl ident shows the correct card "Quatech Spp-100 enhanced parallel port card." I did the make config,make all, and make install in the /usr/src/pcmcia-cs-3.1.14. But I did not see the parport_cs.o in /lib/modules/2.3.99-pre8/pcmcia.

Is there something else that I have missed to install this pcmcia card? Any help would be very much appreciated.

If anyone has or is using the Quatech spp-100 card in the 2.3 kernel, I would like any information about the installation and/or configuration of the card. Thanks

[ Next-in-Thread ]  [ Next Message ] 

Select this message: installing a Quatech spp-100 pcmcia card with 3.1.14 on kernel 2.3.99pre8

Messages Inline: [ 1 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

1. That combo won't work, for now by David Hinds, 2000, Jul 11
(_ Question: what combo will work with parport_cs driver by clfletch@spawar.navy.mil, 2000, Jul 16 (Moved)

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]