[ Next-in-Thread ]  [ Next Message ] 

Question: Unresolved symbols in pcmcia-cs-3.1.19 

Forum: PCMCIA Installation and Configuration Issues
Date: 2000, Aug 07
From: Wenhua Xing Eric 

No problem while building 3.1.19, but when I load the module pcnet_cs, there shows "unresolved symbol" messages for below function call,

ei_open
ethdev_init
register_pccard_driver
unregister_pccard_driver
ei_interrupt
NS8390_init

I tried it in linux kernel 2.2.15 and 2.2.36.

And I have seen "CFLAGS" solution, the same? How to do?

Any idea? Thanks!

[ Next-in-Thread ]  [ Next Message ] 

Select this message: Unresolved symbols in pcmcia-cs-3.1.19

Messages Inline: [ 1 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

1. Don't load PCMCIA modules by hand by David Hinds, 2000, Aug 07
1. More: PCMCIA under pci-pcmcia bridge by Wenhua Xing, 2000, Aug 08
2. Question: Any conflict on this board? by Wenhua Xing, 2000, Aug 08

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]