[ Next-in-Thread ]  [ Next Message ] 

More: PCMCIA under pci-pcmcia bridge 

Forum: PCMCIA Installation and Configuration Issues
Re: Question: Unresolved symbols in pcmcia-cs-3.1.19 (Wenhua Xing)
Re: Don't load PCMCIA modules by hand (David Hinds)
Date: 2000, Aug 08
From: Wenhua Xing Eric 

I get a board with CL-PD6729 as controler to control two pcmcia cards, one sandisk memory card, one linksys pcm100 NIC. 

And the trouble is there are two other pci NICs in the same pci-bus with CL-PD6729. 

That is to say, there are three pci-devicees under the same pci-bridge, and one device is a pci-pcmcia-bridge.

Now I want to make them work together.

And the basic questions are: 
1. Unknow Memory Size;
2. Delay ether0 (conflict?)

Thanks!

[ Next-in-Thread ]  [ Next Message ] 

Select this message: PCMCIA under pci-pcmcia bridge

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]