[ Next-in-Thread ]  [ Next Message ] 

I think you're right: bad network configuration 

Forum: PCMCIA Installation and Configuration Issues
Re: Question: Install and config of Linksys desktop PCMRDWR reader writer and PCM100H1 card (Jeff Gembler)
Re: Getting close, get two beeps on inserting PCMCIA card, but can't ping (Jeff Gembler)
Date: 2000, Apr 05
From: David Hinds <dhinds@pcmcia.sourceforge.org> 

Your network configuration appears to be messed up.  eth0 has a mask
of 255.0.0.0, so it should capture addresses that match 10.*.*.*.
eth2, however, is also on the 10.*.*.* network.  And the broadcast and
netmask for eth2 are inconsistent: you have 10.20.255.255 and
255.255.255.0, but only the following combinations are legal:
10.20.255.255 and 255.255.0.0, or 10.20.0.255 and 255.255.255.0.

-- Dave

[ Next-in-Thread ]  [ Next Message ] 

Select this message: I think you're right: bad network configuration

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]