Next-in-Thread Next Message

Feedback dump_pirq output 

Forum: PCMCIA Installation and Configuration Issues
Re: Question d-link dfe-660tx cardbus: eth0: Tx hung, 9 vs. 0. ?????? (Jochen Kirsch)
Date: 2000, Apr 04
From: Jochen Kirsch cerise

Hello again, here is the output of the dump_pirq script. I hope this helps...

Jochen Kirsch.

==================================================

Interrupt routing table found at address 0xfdf60:
  Version 1.0, size 0x0080
  Interrupt router is device 00:07.0
  PCI exclusive interrupt mask: 0x0000
  Compatible router: vendor 0x8086 device 0x122e

Device 00:01.0 (slot 0):
  INTA: link 0x60, irq mask 0x0200
  INTB: link 0x61, irq mask 0x0200
  INTC: link 0x62, irq mask 0x0200
  INTD: link 0x63, irq mask 0x0200

Device 00:07.0 (slot 0):
  INTD: link 0x63, irq mask 0x0200

Device 00:08.0 (slot 0):
  INTA: link 0x60, irq mask 0x0200
  INTB: link 0x61, irq mask 0x0200

Device 00:09.0 (slot 0):
  INTA: link 0x62, irq mask 0x0200

Device 00:0a.0 (slot 0):
  INTA: link 0x61, irq mask 0x0200
  INTB: link 0x62, irq mask 0x0200

Device 00:0b.0 (slot 0):
  INTA: link 0x60, irq mask 0x0200

Interrupt router: Intel 82371AB PIIX4/PIIX4E PCI-to-ISA bridge
  PIRQ1 (link 0x60): irq 9
  PIRQ2 (link 0x61): irq 9
  PIRQ3 (link 0x62): irq 9
  PIRQ4 (link 0x63): unrouted
  Serial IRQ: [enabled] [quiet] [frame=21] [pulse=4]

Next-in-Thread Next Message

Add Message to: "dump_pirq output"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10