[ Next-in-Thread ]  [ Next Message ] 

Feedback: dump_pirq output 

Forum: PCMCIA Installation and Configuration Issues
Re: Question: d-link dfe-660tx cardbus: eth0: Tx hung, 9 vs. 0. ?????? (Jochen Kirsch)
Date: 2000, Apr 04
From: Jochen Kirsch cerise

Hello again, here is the output of the dump_pirq script. I hope this helps...

Jochen Kirsch.

================================================== 

Interrupt routing table found at address 0xfdf60:
  Version 1.0, size 0x0080
  Interrupt router is device 00:07.0
  PCI exclusive interrupt mask: 0x0000
  Compatible router: vendor 0x8086 device 0x122e

Device 00:01.0 (slot 0):
  INTA: link 0x60, irq mask 0x0200
  INTB: link 0x61, irq mask 0x0200
  INTC: link 0x62, irq mask 0x0200
  INTD: link 0x63, irq mask 0x0200

Device 00:07.0 (slot 0):
  INTD: link 0x63, irq mask 0x0200

Device 00:08.0 (slot 0):
  INTA: link 0x60, irq mask 0x0200
  INTB: link 0x61, irq mask 0x0200

Device 00:09.0 (slot 0):
  INTA: link 0x62, irq mask 0x0200

Device 00:0a.0 (slot 0):
  INTA: link 0x61, irq mask 0x0200
  INTB: link 0x62, irq mask 0x0200

Device 00:0b.0 (slot 0):
  INTA: link 0x60, irq mask 0x0200

Interrupt router: Intel 82371AB PIIX4/PIIX4E PCI-to-ISA bridge
  PIRQ1 (link 0x60): irq 9
  PIRQ2 (link 0x61): irq 9
  PIRQ3 (link 0x62): irq 9
  PIRQ4 (link 0x63): unrouted
  Serial IRQ: [enabled] [quiet] [frame=21] [pulse=4]

[ Next-in-Thread ]  [ Next Message ] 

Select this message: dump_pirq output

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]