Next-in-Thread Next Message

None Several possibilities 

Forum: PCMCIA Installation and Configuration Issues
Re: Question Troubles with Vadem VG-469 - what am I doing wrong? (Andrey Soplevenko)
Date: 2000, Apr 26
From: David Hinds <dhinds@pcmcia.sourceforge.org>

First, does this card have any jumpers for configuring the IO address
for the VG469?  The driver is looking at address 0x3e0 so if there is
a jumper for selecting between other addresses, you should select the
0x3e0 option.

If there is no such jumper, then perhaps this board is set up as an
ISA PnP device.  You can get the linux isapnptools package, and see if
it is able to detect and configure the card.  After that, the PCMCIA
modules should be able to find it.

If neither of these things seems to work, then I'm not sure what's
going on.  Maybe you have some other system device configured so that
it conflicts with the 0x3e0-0x3e1 IO ports needed by the VG-469.  If
you can verify this, you could try moving that other device to some
other IO address, if that's feasible.

-- Dave

Next-in-Thread Next Message

Add Message to: "Several possibilities"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10