Next-in-Thread Next Message

None Several possibilities 

Forum: PCMCIA Installation and Configuration Issues
Re: Question Troubles with Vadem VG-469 - what am I doing wrong? (Andrey Soplevenko)
Date: 2000, Apr 26
From: David Hinds <>

First, does this card have any jumpers for configuring the IO address
for the VG469?  The driver is looking at address 0x3e0 so if there is
a jumper for selecting between other addresses, you should select the
0x3e0 option.

If there is no such jumper, then perhaps this board is set up as an
ISA PnP device.  You can get the linux isapnptools package, and see if
it is able to detect and configure the card.  After that, the PCMCIA
modules should be able to find it.

If neither of these things seems to work, then I'm not sure what's
going on.  Maybe you have some other system device configured so that
it conflicts with the 0x3e0-0x3e1 IO ports needed by the VG-469.  If
you can verify this, you could try moving that other device to some
other IO address, if that's feasible.

-- Dave

Next-in-Thread Next Message

Select this message: Several possibilities

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode Show Frames Help for HyperNews at 1.10
[ Edit This Forum ]