[ Next-in-Thread ]  [ Next Message ] 

More Fiva info 

Forum: Installing Linux using or onto a PCMCIA device
Re: Question: Bug: Lockups on card insertion/removal... (Elliot Lee)
Re: More information? (David Hinds)
Date: 2000, Aug 03
From: Elliot Lee sopwith 

Output of lspci -v:
00:00.0 Host bridge: Cyrix Corporation PCI Master
	Flags: bus master, medium devsel, latency 0

00:01.0 CardBus bridge: Ricoh Co Ltd RL5c475
	Flags: bus master, medium devsel, latency 168
	Memory at <ignored> (32-bit, non-prefetchable)
	Bus: primary=00, secondary=20, subordinate=22, sec-latency=176
	I/O window 0: 00000000-00000003
	I/O window 1: 00000000-00000003
	16-bit legacy interface ports at 0001

00:12.0 ISA bridge: Cyrix Corporation 5520 [Cognac]
	Flags: bus master, medium devsel, latency 0
	I/O ports at 3000
	I/O ports at 4000
	I/O ports at 5000
	Memory at 40010000 (32-bit, non-prefetchable)

00:13.0 USB Controller: Compaq Computer Corporation USB Open Host Controller (rev 04) (prog-if 10 [OHCI])
	Subsystem: Compaq Computer Corporation USB Open Host Controller
	Flags: bus master, medium devsel, latency 64, IRQ 15
	Memory at e0000000 (32-bit, non-prefetchable)

dump_pirq output:
Interrupt routing table found at address 0xfdfa0:
  Version 1.0, size 0x0030
  Interrupt router is device 00:00.0
  PCI exclusive interrupt mask: 0x8000

Device 00:01.0 (slot 1):
  INTA: link 0x01, irq mask 0xdeb8
  INTB: link 0x02, irq mask 0xdeb8
  INTC: link 0x03, irq mask 0xdeb8
  INTD: link 0x04, irq mask 0xdeb8

Interrupt router at 00:00.0: unknown vendor 0x1078 device 0x0001

[ Next-in-Thread ]  [ Next Message ] 

Select this message: More Fiva info

Messages Inline: [ 1 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

1. Ok: Resolved by Elliot Lee, 2000, Aug 03

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]