[ Next-in-Thread ]  [ Next Message ] 

Question: linux-2.4.0-test6, Xircom and i82365 

Forum: Installing Linux using or onto a PCMCIA device
Date: 2000, Aug 16
From: Juergen Rose jrrose

My Xircom Cardbus Adapter CBE which worked properly with older linux versions is not recognized with linux-2.4.0-test6 neither with pcmcia-cs-3.1.19 nor with pcmcia-cs-3.1.20. I configured linux completely without PCMCIA and made an additional installation of pcmcia-cs-3.1.xx. When I boot, "insmod /lib/modules/2.4.0-test6/pcmcia/i82365.o poll_intervall=100" in /etc/rc.d/rc.pcmcia produces: 

  Intel PCIP probe:
     Bridge register mapping failed:
     check cb_mem_base setting

Are there any hints? 

	Juergen

[ Next-in-Thread ]  [ Next Message ] 

Select this message: linux-2.4.0-test6, Xircom and i82365

Messages Inline: [ 1 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

1. More: perhaps an answer?! by Juergen Rose, 2000, Aug 16
2. The PCI support in linux-2.4.0-test6 is broken by David Hinds, 2000, Aug 16

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

[ Members ]  [ Subscribe ]  [ No Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ] 
[ Edit This Forum ]