Next-in-Thread Next Message

None I don't think this is a PCMCIA problem; the messages are fine

Re: Sad contents of dmesg (Pam Akazawa)
Date: 2000, May 01
From: David Hinds <>

I don't know what you mean by "share a printer".  Share with what?  Is
this a printer that directly connects to the network, or a printer
hooked up to another computer?  If you intend to transfer data over
this ethernet card for any purpose, you have to assign an IP address
to your computer.

You almost certainly don't want to be using BOOTP for this.  I think
this is really just a basic network setup question, and not a PCMCIA
problem.  It might be best to check through a book (or the HOWTO's)
for help about how to configure networking.

-- Dave

Next-in-Thread Next Message

Select this message: I don't think this is a PCMCIA problem; the messages are fine

Messages Inline: 1 All Outline: 1 2 All

1. None used this card in the past. by Pam Akazawa, 2000, May 01
(_ None I'm stumped by David Hinds, 2000, May 01
(_ Question ??? IRQ conflict???? by Pam Akazawa, 2000, May 07
(_ None This is not an irq or port problem by David Hinds, 2000, May 08

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode No Frames New Base Frame Help for HyperNews at 1.10
[ Edit This Forum ]