|
Here it is my syslog dump, but apparently everything is fine!!!
Jul 20 21:06:33 ads pcmcia: Starting PCMCIA services: Jul 20 21:06:33 ads pcmcia: modules Jul 20 21:06:33 ads pcmcia: cardmgr. Jul 20 21:06:33 ads rc: Starting pcmcia succeeded Jul 20 21:06:33 ads cardmgr[179]: starting, version is 3.1.8 Jul 20 21:06:33 ads portmap: portmap startup succeeded Jul 20 21:06:33 ads sysctl: net.ipv4.ip_forward = 0 Jul 20 21:06:33 ads sysctl: net.ipv4.conf.all.rp_filter = 1 Jul 20 21:06:33 ads sysctl: net.ipv4.ip_always_defrag = 0 Jul 20 21:06:33 ads sysctl: kernel.sysrq = 0 Jul 20 21:06:33 ads network: Setting network parameters succeeded Jul 20 21:06:33 ads cardmgr[179]: initializing socket 0 <30>Jul 20 21:06:33 cardmgr[179]: socket 0: NE2000 Compatible Ethernet Jul 20 21:06:34 ads cardmgr[179]: executing: 'insmod/lib/modules/2.2.16-3/pcmcia/pcnet_cs.o'
Jul 20 21:06:34 ads network: Bringing up interface lo succeeded Jul 20 21:06:34 ads ifup: SIOCADDRT: File exists Jul 20 21:06:34 ads last message repeated 2 times Jul 20 21:06:34 ads network: Bringing up interface eth0 succeeded Jul 20 21:06:34 ads nfslock: rpc.lockd startup succeeded Jul 20 21:06:34 ads nfslock: rpc.statd startup succeeded I tried also "test_network", and this is the output: PCMCIA network settings are coming from linuxconf. Checking network interface eth0 (pcnet_cs driver):
Kernel messages for eth0: eth0: NE2000 Compatible: io 0x300, irq 9, hw_addr 00:E0:98:34:F0:0A eth0: found link beat eth0: lost link beat
Current ifconfig settings:
eth0 Link encap:Ethernet HWaddr 00:E0:98:34:F0:0A
inet addr:137.138.102.76 Bcast:137.138.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2317 errors:0 dropped:0 overruns:0 frame:0
TX packets:541 errors:0 dropped:0 overruns:0 carrier:0
collisions:3 txqueuelen:100
Interrupt:9 Base address:0x300
The interface is configured and running. RX and TX traffic both look ok.
Enter a numeric IP address to ping: 137.138.1.1
Pinging 137.138.1.1 ... response received! The device interrupt seems to be incrementing normally. So, what I should conclude from here is that everything is fine, but... still only ~50 Kb/s of transfer rate. Any idea? Thanks
|
Messages