[ Next-in-Thread ]  [ Next Message ] 

Interrupt setup problem 

Forum: PCMCIA Network Adapter Issues
Re: "eth0: Tx hung, 9 vs 0." from NETGEAR FA510c (David Brooks)
Date: 2000, Aug 02
From: David Hinds <dhinds@pcmcia.sourceforge.org> 

No interrupts are getting through from the card.  It is a problem with
the CardBus bridge configuration, not a problem with the card.

Could you post the output of the "dump_pirq" script from the
debug-tools subdirectory of the PCMCIA package?

I suspect it won't help, but you could also try bumping the card onto
a different interrupt by excluding irq 3 in /etc/pcmcia/config.opts.

-- Dave

[ Next-in-Thread ]  [ Next Message ] 

Messages Inline: [ 1 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

1. Ok: Problem solved; card working! by David Brooks, 2000, Aug 03
2. Question: Another Netgear FA510c problem by Ed Hill, 2000, Aug 08

[ Add Message ]  to: "Interrupt setup problem"

[ Members ]  [ Subscribe ]  [ Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ]