> Maybe the card is confused about whether this is a full or half duplex > link. Thats what I though, too, since the LED saying Half/Full Duplex always goes on and off when there is traffic. > What sort of device are you connecting to? Hub or switch? Its a micronet switch.
> Do > you know if it supports autonegotiation? I have no documentation, so I dont - any way to figure it out ?
> Try adding to /etc/pcmcia/config.opts a line like > > module "tulip_cb" opts "options=N" If I do so, the card wont work at all. Even if I put "11" in there, which is the mode the card is usually in, it wont work. The logs dont say much besides eth0: Using user-specified media MII and I got a kernel: eth0: Tx hung, 29 vs. 11. a few times. Anything else I can try ? thanks, M.Melms
|
Messages