Question: dynalink lc10 network can't initialise 

Forum: PCMCIA Network Adapter Issues
Date: 1999, Nov 29
From: digit

Hi, My dynalink LC10 pcmcia card works with windows. If checked the irq's and memory vallues and copied these ranges to linux :/etc/pcmcia/config.opts messages say everything works modules, irq mem but ./network start eth0 failes because eth0 doesn't exist. I allso get twe high low beep on boot and after insert. Using redhat 6.1 the card is in the supported database and is recognised as NE2000 compatible (messages sya this) Is this card indeed supported? The irq 3 is really free in my case and the mem seems right to. When remomving the high memory range from config.options I get the right beeps but the card is then a mem0 device and nothing eth0 like. Thsi is ll I know is there someone thaT KNOWS WHAT TO DO OR IS THIS CARD SIMPLY NOT SUPPORTED?

[ Next-in-Thread ]  [ Next Message ] 

Messages Inline: [ 0 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

The actual messages would help Re: Question: dynalink lc10 network can't initialise Date: 1999, Nov 29 From: David Hinds <dhinds@pcmcia.sourceforge.org>

> > messages say everything works modules, irq mem but ./network start eth0 > failes because eth0 doesn't exist. It would help to show the actual messages, because I can't really tell what's going on from your summary. It might be something trivial, like you haven't done a "netconf" to enter your network settings yet. -- Dave

1. messages for compaqua armada 1750 by digit@dds.nl, 1999, Nov 30 (_ No real problems here by David Hinds, 1999, Nov 30 (_ Thanks!! by digit@dds.nl, 1999, Dec 01

[ Add Message ]  to: "dynalink lc10 network can't initialise"

[ Members ]  [ Subscribe ]  [ Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ]