Next-in-Thread Next Message

None Problems with 3c575 and CEM33 on an NEC Versa LX 

Forum: PCMCIA Network Adapter Issues
Date: 1999, Dec 13
From: Brian Mays brian

This message describes problems with two pcmcia cards. One is a 3com cardbus 10/100 (3c575), the other is a Xircom pccard CEM33 (10bt ethernet+modem 33.6). These cards are being used with an NEC Versa LX laptop.

The 3com card works ok except when ftping a file (of say, 184mb) the system freezes and there are messages on the console. They are

  eth0: Host error, FIFO diagnostic register 0000.
        This message repeats 21 times
  eth0: Too much work in interrupt, status 8003.  Temporarily disabling
        functions (7ffc).

At that point, the system is completely unusable. If the card is ejected, the kernel oops's and the system is still unusable. Note that the error messages for the oops are unavailable, since it was very long and difficult to capture.

The Xircom card freezes the system. No messages are printed. When ejecting the card, the display shifts. Column 1 starts in the middle of the screen. The system is completely unusable after inserting the card.

Before upgrading to pcmcia 3.1.5, version 3.1.1 was installed. The 3com card has experienced problems with both versions. The Xircom adapter worked under the 3.1.1 version, but not 3.1.5.

Next-in-Thread Next Message

Select this message: Problems with 3c575 and CEM33 on an NEC Versa LX

Messages Inline: 1 All Outline: 1 2 All

1. None A favorable resolution on both counts by David Hinds, 1999, Dec 17

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.


If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO


If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO


Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10
[ Edit This Forum ]