More: Argosy 10/100 more info 

Forum: PCMCIA Network Adapter Issues
Re: Question: Argosy 10/100 EN-235 (Robert Rossmann)
Date: 2000, Feb 17
From: Robert Rossmann rbr

I insert the memory region 0x5042000-0x50421ff which I found from the Windows driver of these card. Now the output of cardctl ident is Socket 1: produkt info: " ARGOSY", "CardBus Ethernet 10/100 (R5)" function: 6 (network) and of cardctl config is Socket 1: Vcc 3.3V Vpp1 3.3V Vpp2 3.3V interface type is "cardbus" function 0: I tried to use this info in the config file but still the card won't work. Must I do anythink else to use a 32bit cardbus card? thx Robert

[ Next-in-Thread ]  [ Next Message ] 

Messages Inline: [ 0 ]  [ All ]  Outline: [ 1 ]  [ 2 ]  [ All ] 

Re: More: Argosy 10/100 more info Re: More: Argosy 10/100 more info (Robert Rossmann) Date: 2000, Feb 17 From: David Hinds <dhinds@pcmcia.sourceforge.org>

> > I tried to use this info in the config file but still the card won't > work. Must I do anythink else to use a 32bit cardbus card? What did you add to the config file, exactly? (what driver did you specify?) You could try either tulip_cb or epic_cb; tulip_cb would be the more likely guess. If those don't work, then this card would appear to use an unsupported CardBus network controller (all the other PCMCIA network drivers are strictly for 16-bit cards). -- Dave

1. More: Used both tulip_cb and epic_cb by Robert Rossmann, 2000, Feb 18 (_ More: More info by Robert Rossmann, 2000, Feb 21 (_ You are currently out of luck by David Hinds, 2000, Feb 21

[ Add Message ]  to: "Argosy 10/100 more info"

[ Members ]  [ Subscribe ]  [ Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ]