Next-in-Thread Next Message

Sad ND5120-E Card seems to be alive, but cannot ping. 

Forum: PCMCIA Network Adapter Issues
Date: 2000, Feb 22
From: Martin Andrews mdda

I believe that my card is 'alive', and pinging outside the machine causes the little lights to flash.  However, no other machine will respond to pings (nor will the Presario respond to their pings).

This is an install of RedHat 6.1 out-of-the-box.  Should I be recompiling the PCMCIA from your source?

Many thanks for any help you can give me.

Machine : Compaq Presario 1622, SohoWare ND5120-E 10bT card

:::: dmesg :::::
Linux version 2.2.12-20 ( (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #1 Mon Sep 27 10:25:54 EDT 1999
Linux PCMCIA Card Services 3.0.14
  kernel build: 2.2.12-20 #1 Mon Sep 27 10:25:54 EDT 1999
  options:  [pci] [cardbus] [apm]
Intel PCIC probe: 
  TI 1131 PCI-to-CardBus at bus 0 slot 10, mem 0x68000000, 2 sockets
    host opts [0]: [ring] [pci + serial irq] [no pci irq] [lat 168/176] [bus 32/34]
    host opts [1]: [ring] [pci + serial irq] [no pci irq] [lat 168/176] [bus 35/37]
    ISA irqs (scanned) = 3,4,7,10 status change on irq 10
cs: IO port probe 0x1000-0x14ff: clean.
cs: memory probe 0x60000000-0x60ffffff: clean.
eth0: NE2000 Compatible: io 0x1000, irq 3, hw_addr 00:C0:F0:1C:FF:FF
eth0: bogus packet size: 8481, status=0x21 nxpg=0x40.

:::: ifconfig status ::::
Socket 0:
  no card
Socket 1:
  5V 16-bit card present
  Function 0: ready

:::: ifconfig ident ::::
Socket 0:
  no product info available
Socket 1:
  product info: "NDC", "Ethernet", "A", "004743118001"
  function: 6 (network)

:::: ifconfig eth0 ::::
eth0      Link encap:Ethernet  HWaddr 00:C0:F0:1C:FF:FF  
          inet addr:  Bcast:  Mask:
          RX packets:0 errors:26 dropped:0 overruns:0 frame:1
          TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          Interrupt:3 Base address:0x1000 

:::: route ::::
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface    *      UH    0      0        0 eth0     *        U     0      0        0 eth0       *            U     0      0        0 lo

Next-in-Thread Next Message

Add Message to: "ND5120-E Card seems to be alive, but cannot ping."

Members Subscribe Admin Mode Show Frames Help for HyperNews at 1.10