I believe that my card is 'alive', and pinging outside the machine causes the little lights to flash. However, no other machine will respond to pings (nor will the Presario respond to their pings). This is an install of RedHat 6.1 out-of-the-box. Should I be recompiling the PCMCIA from your source? Many thanks for any help you can give me. Martin :-) Machine : Compaq Presario 1622, SohoWare ND5120-E 10bT card :::: dmesg ::::: Linux version 2.2.12-20 (root@porky.devel.redhat.com) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #1 Mon Sep 27 10:25:54 EDT 1999 ... Linux PCMCIA Card Services 3.0.14 kernel build: 2.2.12-20 #1 Mon Sep 27 10:25:54 EDT 1999 options: [pci] [cardbus] [apm] Intel PCIC probe: TI 1131 PCI-to-CardBus at bus 0 slot 10, mem 0x68000000, 2 sockets host opts [0]: [ring] [pci + serial irq] [no pci irq] [lat 168/176] [bus 32/34] host opts [1]: [ring] [pci + serial irq] [no pci irq] [lat 168/176] [bus 35/37] ISA irqs (scanned) = 3,4,7,10 status change on irq 10 cs: IO port probe 0x1000-0x14ff: clean. cs: memory probe 0x60000000-0x60ffffff: clean. eth0: NE2000 Compatible: io 0x1000, irq 3, hw_addr 00:C0:F0:1C:FF:FF eth0: bogus packet size: 8481, status=0x21 nxpg=0x40. :::: ifconfig status :::: Socket 0: no card Socket 1: 5V 16-bit card present Function 0: ready :::: ifconfig ident :::: Socket 0: no product info available Socket 1: product info: "NDC", "Ethernet", "A", "004743118001" function: 6 (network) :::: ifconfig eth0 :::: eth0 Link encap:Ethernet HWaddr 00:C0:F0:1C:FF:FF inet addr:192.168.1.12 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:26 dropped:0 overruns:0 frame:1 TX packets:9 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 Interrupt:3 Base address:0x1000 :::: route :::: Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.12 * 255.255.255.255 UH 0 0 0 eth0 192.168.1.0 * 255.255.255.0 U 0 0 0 eth0 127.0.0.0 * 255.0.0.0 U 0 0 0 lo |