thanx for your quick reply!!
/etc/pcmcia/config:
...
card "LN1078"
manfid 0xffff, 0x1090
bind "pcnet_cs"
...
/etc/pcmcia/config.opts
...
module "pcnet_cs" opts "hw_addr=0x00,0x00,0x21,0x0e,0x--,0x--"
...
#dmesg //after a /etc/rc.d/init.d/pcmcia restart & command "route" was executed
unloading PCMCIA Card Services
Linux PCMCIA Card Services 3.1.13
kernel build: 2.2.12-20 #1 Mon Sep 27 10:40:35 EDT 1999
options: [pci] [cardbus] [apm]
PCI routing table version 1.0 at 0xfdf70
Intel PCIC probe:
TI 1225 PCI-to-CardBus at slot 00:04, mem 0x68000000
host opts [0]: [ring] [serial pci & irq] [pci irq 11] [lat 64/176] [bus 32/34]
host opts [1]: [ring] [serial pci & irq] [pci irq 11] [lat 64/176] [bus 35/37]
PCI irq 11 seems to be wedged!
PCI irq 11 test failed
ISA irqs (default) = 3,4,5,7,9,10 polling interval = 1000 ms
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: excluding 0x378-0x37f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
eth0: NE2000 Compatible: io 0x300, irq 3, hw_addr 00:00:21:0E:--:-- //sorry for hide this.
eth0: interrupt from stopped card
eth0: interrupt(s) dropped!
eth0: Reentering the interrupt handler! isr=0x0 imr=0x0.
eth0: Reentering the interrupt handler! isr=0x0 imr=0x0.
can these messages help?
i compiled & installed pcmcia-cs-3.1.13 using default options.
PS:
this poor card is called ln1078.
Based on IEEE 802.30Base-T,IEEE 802.3u 100Base-TX
ioport 0x240-0x360
irq 2,3,4,5,10,11,12,15
data cache buffer 64k
it can work at 10M/100M duplex mode.
info can be get at http://www.legend.com.cn but it is build in chinese language. :(
many laptop users in china use this card like me. diff is they use windoz i use linux. :)
|
Messages