Next-in-Thread Next Message

Question Seems to be an issue with my notebook 

Forum: PCMCIA Network Adapter Issues
Re: None Slow connections with Genius MF3000 ? (Thomas Moestl)
Re: None I don't know if this is unusual (David Hinds)
Date: 2000, Jun 03
From: Thomas Moestl whoo

This seems actually to be a problem with my notebook. The same card works fine (and fast) on a friend's notebook. I also tried a 3cXFE575BT. Again, this is fairly slow with my notebook (even worse than the MF3k), but works fine with other laptops. Is it possible that this is a driver problem, or is it flawed hardware? Here some boot messages:

Jun  3 13:20:31 flux kernel: Linux PCMCIA Card Services 3.1.14
Jun  3 13:20:31 flux kernel:   kernel build: 2.2.15 #1 Fri May 5 21:29:34 MEST 2000
Jun  3 13:20:31 flux kernel:   options:  [pci] [cardbus] [apm]
Jun  3 13:20:31 flux kernel: PCI routing table version 1.0 at 0xfdf60
Jun  3 13:20:31 flux kernel:   00:0a.0 -> irq 9
Jun  3 13:20:31 flux kernel: Intel PCIC probe: 
Jun  3 13:20:31 flux kernel:   Ricoh RL5C478 rev 80 PCI-to-CardBus at slot 00:0a, mem 0x68000000
Jun  3 13:20:31 flux kernel:     host opts [0]: [isa irq] [io 3/6/1] [mem 3/6/1] [pci irq 9] [lat 168/176] [bus 32
Jun  3 13:20:31 flux kernel:     host opts [1]: [isa irq] [io 3/6/1] [mem 3/6/1] [pci irq 9] [lat 168/176] [bus 35
Jun  3 13:20:31 flux kernel:     PCI irq 9 test failed
Jun  3 13:20:31 flux kernel:     ISA irqs (default) = 3,4,5,7,10,11,12 polling interval = 1000 ms
Jun  3 13:20:31 flux kernel: cs: IO port probe 0x1000-0x17ff: clean.
Jun  3 13:20:31 flux kernel: cs: IO port probe 0x0100-0x04ff: excluding 0x140-0x147 0x378-0x37f 0x4d0-0x4d7

Next-in-Thread Next Message

Select this message: Seems to be an issue with my notebook

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.


If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO


If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO


Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10
[ Edit This Forum ]