Next-in-Thread Next Message

None It should actually work

Re: Question Panasonic KXL-783A: Let's try this again... (Mike Bilow)
Date: 2000, Mar 28
From: David Hinds <dhinds@pcmcia.sourceforge.org>

The 0xa50 IO address is not a problem.  This:

>     cftable_entry 0x25
>       io 0x240-0x25f [lines=10] [16bit] [range]

means that the card actually only decodes the lower 10 address lines,
so if X is ok, then X+0x400, X+0x800, etc are all ok.

Did you have the SCSI cd-rom driver loaded when you tested the card?
(if not, the CD-ROM will be ignored, consistent with your messages)

-- Dave

Next-in-Thread Next Message

Select this message: It should actually work

Messages Inline: 1 All Outline: 1 2 All

1. None Not quite what I meant... by Mike Bilow, 2000, Mar 28
(_ None The card decodes 10 bits, the bridge decodes 16 bits by David Hinds, 2000, Mar 28

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.


If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO


If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO


Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode No Frames New Base Frame Help for HyperNews at pcmcia-cs.sourceforge.net 1.10
[ Edit This Forum ]