Next-in-Thread Next Message

Question Panasonic CD Rom KXL-D720 

Forum: PCMCIA SCSI Host Adapter Issues
Date: 2000, May 04
From: Steve Thomas <stevet@sb.net>

I've successfully installed RedHat 6.1 on my Toshiba Satellite 110CS and have most everything working. However, I can't get it to recognize my CD ROM which is attached to a scsi pcmcia card. The CD is on the list of devices that should work (tho not directly supported.) It is a Panasonic KXL-D720.

When I insert the card, the following message comes up:

parport0: detected irq 7; use procfs to enable interrupt-driven operation.

Is "procfs" a utility that I can use to make the fix? I can't find it anywhere in my linux set-up. Also, when I run the following commands for the card services, I get the results noted:

#cardctl config
Socket 0:
  Vcc = 5.0, Vpp1 = 0.0, Vpp2 = 0.0
  Interface type is memory and I/O
  IRQ 3 is exclusive, level mode, enabled
  Function 0:
    Config register base = 0x0200
      Option = 0x68, status = 0000, pin = 0000, copy = 0000
    I/O window 1: 0x0100 to 0x011f, 8 bit
Socket 1:
  not configured

#cardctl ident
Socket 0:
  product info: "KME", "KXLC001", "00"
  manfid: 0x0032, 0x0104
  function: 3 (parallel)
Socket 1
  no product info available

What do I need to do to get this thing working? I'm a REAL novice here and, despite reading the PCMCIA How-To, I still haven't a clue as to what to do.

Thanks for the help.

Steve

Next-in-Thread Next Message

Select this message: Panasonic CD Rom KXL-D720

Messages Inline: 1 All Outline: 1 2 All

1. None You're misunderstanding the "not supported" bit by David Hinds, 2000, May 04
2. More Not Supported by Steve Thomas, 2000, May 04
1. None Not the KXL-D720 by David Hinds, 2000, May 04
(_ Ok OK by Steve Thomas, 2000, May 04

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.


If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination
NO


If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages
NO


Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10
[ Edit This Forum ]