|
Hi again
Yeah, i did make sure the SCSI disk drivers were there. First
compiled the SCSI support into the kernel, then tried it as a
module exactly as you suggestedin the how-to. Still no dice.
Here's the dmseg output resulting form booting with the SCSI
disk driver as a module:
----------------------------------------------------------
Linux PCMCIA Card Services 3.1.16
kernel build: 2.2.16 #9 Mon Aug 7 20:27:13 PDT 2000
options: [pci] [cardbus] [apm] [pnp]
PCI routing table version 1.0 at 0xfe840
00:0a.1 -> irq 10
PnP: PNP BIOS installation structure at 0xc00ff020
PnP: PNP BIOS version 1.0, entry at ec000:21d5, dseg at ec000
Intel PCIC probe:
TI 1225 rev 01 PCI-to-CardBus at slot 00:0a, mem 0x68000000
host opts [0]: [ring] [serial pci & irq] [pci irq 10] [lat 168/176] [bus 32/34]
host opts [1]: [ring] [serial pci & irq] [pci irq 10] [lat 168/176] [bus 35/37]
ISA irqs (default) = 9,11 PCI status changes
cs: IO port probe 0x1000-0x17ff: clean.
cs: IO port probe 0x0100-0x04ff: clean.
cs: IO port probe 0x0a00-0x0aff: clean.
cs: cb_alloc(bus 32): vendor 0x9004, device 0x6075
ROM image dump:
image 0: 0x000000-0x0001ff, signature PCIR
image 1: 0x000200-0x0003ff, signature PCIR
cs: cb_config(bus 32)
fn 0 bar 1: io 0xa00-0xaff
fn 0 bar 2: mem 0x60030000-0x60030fff
fn 0 rom: mem 0x60020000-0x6002ffff
irq 10
cs: cb_enable(bus 32)
bridge io map 0 (flags 0x21): 0xa00-0xaff
bridge mem map 0 (flags 0x1): 0x60020000-0x60030fff
apa1480_attach(device 20:00.0)
aic7xxx: <Adaptec PCMCIA SCSI controller> at PCI 32/0/0
aic7xxx: MMAPed I/O failed, reverting to Programmed I/O.
(scsi0) <Adaptec PCMCIA SCSI controller> found at PCI 32/0/0
(scsi0) Narrow Channel, SCSI ID=7, 3/255 SCBs
(scsi0) Downloading sequencer code... 423 instructions downloaded
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.28/3.2.4
<Adaptec PCMCIA SCSI controller>
scsi : 1 host.
apa1480_cs: no SCSI devices found
scsi : 0 hosts.
cs: cb_disable(bus 32)
cs: cb_release(bus 32)
-------------------------------------------------------------
Any other thoughts? Thanks again for all your help. a
|