|
hi there,
as newbie I definitively need help setting up 2
Pcmcia Cards running on a Sony Vaio F-305 under Suse Linux.
card 1 = Modemcard Com1 V.90 MC221 Discovery 56K (it is not supported by the package - but i think it should work if I could find out the right interrupts..)- but how ? card 2 = Ethernetcard Argosy EN 235 10/100 ( I think it is supported, but cardctl and cardmanager always say there is nothing loaded...) also I don`t know what to write into the config file... here is a boot.message printout: ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS02 at 0x03e8 (irq = 4) is a 16550A
Linux PCMCIA Card Services 3.1.3 kernel build: 2.2.13 #1 Mon Nov 8 18:28:35 GMT 1999
options: [pci] [cardbus] [pnp] PnP: PNP BIOS installation structure at 0xc00f6e00 PnP: PNP BIOS version 1.0, entry at f0000:b54f, dseg at 400 PCI routing table version 1.0 at 0xfdf60 00:0a.0 -> irq 9 Intel PCIC probe: Ricoh RL5C478 PCI-to-CardBus at bus 0 slot 10, mem 0x68000000, 2 sockets host opts [0]: [isa irq] [io 3/6/1] [mem 3/6/1] [pci irq 9] [lat 168/176] [bus 32/34] host opts [1]: [isa irq] [io 3/6/1] [mem 3/6/1] [no pci irq] [lat 168/176] [bus 35/37] ISA irqs (default) = 3,4,5,7,10,11,12 polling interval = 1000 ms cs: IO port probe 0x1000-0x17ff: clean. cs: IO port probe 0x0100-0x04ff: clean. cs: IO port probe 0x0a00-0x0aff: clean. cs: cb_alloc(bus 32): vendor 0x10ec, device 0x8138 cs: cb_alloc(bus 35): vendor 0xffff, device 0x0440 hdc: packet command error: status=0x51 { DriveReady SeekComplete Error } hdc: packet command error: error=0x50
ATAPI device hdc: Error: Illegal request -- (Sense key=0x05)
Invalid field in command packet -- (asc=0x24, ascq=0x00) The failed "Start Stop Unit" packet command was: "1b 00 00 00 03 00 00 00 00 00 00 00 " Error in command packet byte 256 bit 0 cdrom: open failed. VFS: Disk change detected on device ide1(22,0) to be honest, I don`t really know what it means... pleeeeez help me ... thanx in advance red
|
Messages