I have a new 1555CDS (PCI/Cardbus) and have the opposite problem described in the documentation: at bootup I get a low beep then high beep. Unlike my ISA/Cardbus 335CDS, I don't get a "clean" memory probe report in syslog, only "excluding ...". I have tried limiting ranges without success so far. I started with all the default 3.0.14 config files from Redhat. In any case, cards report as "Anonymous memory" and fail to config if inserted at boot time. If the same card is removed and reinserted any time after boot, it will be configured properly. If no card is inserted at boot, everything also works fine. I'm using only older cards (modem, ethernet), no Cardbus cards, and the Cardbus mode is turned off in the bios (nothing worked until I disabled it). Any suggestions will be appreciated. Paul |
Messages