Next-in-Thread Next Message

None Toshiba Portege 3015CT (ToPIC97 rev 6) 

Forum: PCMCIA on Toshiba laptops
Re: News I need revision info for ToPIC bridges... (David Hinds)
Date: 2000, Jun 26
From: KevinArima Starfox

  Bus  0, device  19, function  0:
    CardBus bridge: Toshiba ToPIC97 (rev 6).
      Slow devsel.  Fast back-to-back capable.  Master Capable.  No bursts.  Min Gnt=128.Max Lat=4.

This is on a Toshiba Portege 3015CT (3010-3025 is all the same) using BIOS Setting of Auto for the PCMCIA controller. If the PCMCIA controller is changed to Cardbus/16-bit, then Linux reports it being a ToPIC95B.

Haven't had any problems so far other than certain card issues which were fixed in 3.1.16. Have used the following cards: 3Com 3C574-TX (10/100 16-bit) 3Com 3CCFE575CT (10/100 CardBus) 3Com 3CXFEM656C (10/100-Modem Cardbus - eth interface only) 3Com 3CXM056-BNW (Modem 16-bit) SanDisk CompactFlash Adapter (CF 16-bit) Megahertz XJAEM3336 (10bT-Modem 16-bit) Addonics ATA Adapter (IDE 16-bit)

Next-in-Thread Next Message

Select this message: Toshiba Portege 3015CT (ToPIC97 rev 6)

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode Show Frames Help for HyperNews at 1.10
[ Edit This Forum ]