Context: laptop Toshiba Satellite Pro 4270 running kernel
2.2.15, pcmcia 3.1.15 with a Xircom CBEII-10/100 Cardbus card.
I was running succesfully a pre 3.1.15 version (~ May 15) of
the PCMCIA drivers. It was usable but I have to make some
manipulations to get it started after each reboot (else,
the interface was up but no way to pass a single packet).
I've decided to upgrade to 3.1.15 today but now,
the system crashes systematically while loading the module
i82365.o (no way to recover, not even with magic sysReq).
I've also tried pre-3.1.16 (01-Jun-00) but it is the same
thing. Strangely, I'm able to start the pcmcia service while
in "single user" mode.. but I'm unable to pass a single
packet :( Unfortunatly, I've overwrited my pre-3.1.15 copy
(with final 3.1.15) and it's no longer available on the
ftp site so I'm not able to downgrade :((
Here is the lspci output (bridge, cardbus briges, xircom
card [from the single user boot]) :
00:05.3 Bridge: Intel Corporation 82371AB PIIX4 ACPI (rev 03)
00:0b.0 CardBus bridge: Toshiba America Info Systems ToPIC95 PCI to Cardbus Bridge with ZV Support (rev 20)
00:0b.1 CardBus bridge: Toshiba America Info Systems ToPIC95 PCI to Cardbus Bridge with ZV Support (rev 20)
10:00.0 Ethernet controller: Xircom Cardbus Ethernet 10/100 (rev 03).
When it is working, here is the output of 'insmod i82365.o' :
Intel PCIC probe:
Toshiba ToPIC100 rev 20 PCI-to-CardBus at slot 00:0b, mem 0x68000000
host opts [0]: [slot 0xf0] [ccr Ox10] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 20/20]
host opts [1]: [slot 0xf0] [ccr Ox20] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 21/21]
ISA irqs (default) = 4,5,7,9,10,12 PCI status changes
Else, no output [ even with PCMCIA_DEBUG=1 ]
As it crashes even when the slots are all empty, I don't
think this is a Xircom problem.
Any idea ?
|
[ Edit This Forum ]