|
Hi Dave and All, I have: Toshiba Tecra 8100 (320Mb memory) Ositech Jack of Spades Mandrake 7.1 pcmcia-cs-3.1.19 I think I'm close to have it up but I need some HELP. The card looks like is started OK (got the 2 high beeps with both the card in during boot or card inserted after boot; more, cardctl commands: suspend resume reset eject and insert are working OK) and the network is started for the localhost: >ifconfig -a eth0 Link encap:Ethernet HWaddr 00:C0:E3:27:05:16 inet addr:192.168.0.30 Bcast:192.168.0.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 Interrupt:11 Base address:0x1100 But, I can not see any green light on my switch indicating that the card is up (which I can get with the same identical card & CAT5 cable when using WinNT and the driver provided by Ositech for Micros..t). If I try ">route add 192.162.0.10" I get: "SIOCADDRT: No such device" At this point, after a couple of days of work_code_and_docs_study, I decided to give up and ask for HELP. Thanks Cristian -------------------------------------------------------------- a. My /etc/sysconfig/pcmcia is : PCMCIA=yes PCIC=i82365 b. My /etc/pcmcia/config.opts is: # # Local PCMCIA Configuration File # include port 0x100-0x477, port 0x1000-0x17ff include memory 0xc0000-0xfffff include memory 0xa0000000-0xa0ffffff exclude irq 3 exclude irq 4 exclude irq 5 exclude irq 7 exclude irq 9 exclude irq 12 exclude irq 14 exclude irq 15 c. My /etc/sysconfig/network-scripts/networks.opts is if [ -f /etc/sysconfig/network-scripts/ifcfg-eth0 ] ; then start_fn() { /sbin/ifup $1 } stop_fn() { /sbin/ifdown $1 } fi After boot info: >dmesg Linux PCMCIA Card Services 3.1.19 kernel build: 2.2.15-4mdk #1 Wed May 10 15:31:30 CEST 2000 options: [pci] [cardbus] [apm] PCI routing table version 1.0 at 0xf0140 00:0b.0 -> irq 11 00:0b.1 -> irq 11 ds: no socket drivers loaded! unloading PCMCIA Card Services Linux PCMCIA Card Services 3.1.19 kernel build: 2.2.15-4mdk #1 Wed May 10 15:31:30 CEST 2000 options: [pci] [cardbus] [apm] PCI routing table version 1.0 at 0xf0140 Intel PCIC probe: Toshiba ToPIC95-B rev 07 PCI-to-CardBus at slot 00:0b, mem 0x68000000 host opts [0]: [slot 0xf0] [ccr 0x10] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 20/20] host opts [1]: [slot 0xf0] [ccr 0x20] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 21/21] ISA irqs (default) = 3,4,5,7,9,10,12 PCI status changes cs: IO port probe 0x1000-0x17ff: clean. cs: IO port probe 0x0100-0x0477: excluding 0x330-0x337 0x378-0x37f cs: cb_alloc(bus 20): vendor 0x10b8, device 0x0006 ROM image dump: image 0: 0x000000-0x000bff, signature PCIR epic100.c:v1.07h 8/18/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/epic100.html cs: cb_config(bus 20) fn 0 bar 1: io 0x1100-0x11ff fn 0 bar 2: mem 0xa0041000-0xa0041fff fn 1 bar 1: io 0x1000-0x10ff fn 1 bar 2: mem 0xa0040000-0xa0040fff fn 0 rom: mem 0xa0030000-0xa003ffff fn 1 rom: mem 0xa0020000-0xa002ffff irq 11 cs: cb_enable(bus 20) bridge io map 0 (flags 0x21): 0x1000-0x11ff bridge mem map 0 (flags 0x1): 0xa0020000-0xa0041fff epic_attach(bus 20, function 0) eth0: <NULL> at 0x1100, IRQ 11, 00:c0:e3:27:05:16. eth0: MII transceiver #1 control 3100 status 7809. eth0: Autonegotiation advertising 01e1 link partner 0000. serial_attach(device 14:00.1) tty01 at 0x1000 (irq = 11) is a 16550A >cat /var/log/messages ... Aug 5 00:15:37 localhost pcmcia: Starting PCMCIA services: Aug 5 00:15:37 localhost pcmcia: modules Aug 5 00:15:37 localhost kernel: Linux PCMCIA Card Services 3.1.19 Aug 5 00:15:37 localhost kernel: kernel build: 2.2.15-4mdk #1 Wed May 10 15:31:30 CEST 2000 Aug 5 00:15:37 localhost kernel: options: [pci] [cardbus] [apm] Aug 5 00:15:37 localhost kernel: PCI routing table version 1.0 at 0xf0140 Aug 5 00:15:37 localhost kernel: Intel PCIC probe: Aug 5 00:15:37 localhost kernel: Toshiba ToPIC95-B rev 07 PCI-to-CardBus at slot 00:0b, mem 0x68000000 Aug 5 00:15:37 localhost kernel: host opts [0]: [slot 0xf0] [ccr 0x10] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 20/20] Aug 5 00:15:37 localhost kernel: host opts [1]: [slot 0xf0] [ccr 0x20] [cdr 0x86] [rcr 0xc000000] [pci irq 11] [lat 64/176] [bus 21/21] Aug 5 00:15:37 localhost kernel: ISA irqs (default) = 3,4,5,7,9,10,12 PCI status changes Aug 5 00:15:37 localhost pcmcia: cardmgr. Aug 5 00:15:37 localhost rc: Starting pcmcia succeeded Aug 5 00:15:37 localhost cardmgr[410]: starting, version is 3.1.19 Aug 5 00:15:37 localhost cardmgr[410]: watching 2 sockets Aug 5 00:15:37 localhost kernel: cs: IO port probe 0x1000-0x17ff: clean. Aug 5 00:15:37 localhost kernel: cs: IO port probe 0x0100-0x0477: excluding 0x330-0x337 0x378-0x37f Aug 5 00:15:38 localhost kernel: cs: cb_alloc(bus 20): vendor 0x10b8, device 0x0006 Aug 5 00:15:38 localhost cardmgr[410]: initializing socket 0 Aug 5 00:15:38 localhost cardmgr[410]: socket 0: Ositech Jack of Spades Fast Ethernet/Modem Aug 5 00:15:38 localhost cardmgr[410]: executing: 'modprobe cb_enabler' Aug 5 00:15:38 localhost cardmgr[410]: executing: 'modprobe epic_cb' Aug 5 00:15:38 localhost kernel: epic100.c:v1.07h 8/18/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/epic100.html Aug 5 00:15:38 localhost cardmgr[410]: executing: 'modprobe serial_cb' Aug 5 00:15:38 localhost kernel: cs: cb_config(bus 20) Aug 5 00:15:38 localhost kernel: fn 0 bar 1: io 0x1100-0x11ff Aug 5 00:15:38 localhost kernel: fn 0 bar 2: mem 0xa0041000-0xa0041fff Aug 5 00:15:38 localhost kernel: fn 1 bar 1: io 0x1000-0x10ff Aug 5 00:15:38 localhost kernel: fn 1 bar 2: mem 0xa0040000-0xa0040fff Aug 5 00:15:38 localhost kernel: fn 0 rom: mem 0xa0030000-0xa003ffff Aug 5 00:15:38 localhost kernel: fn 1 rom: mem 0xa0020000-0xa002ffff Aug 5 00:15:38 localhost kernel: irq 11 Aug 5 00:15:39 localhost kernel: eth0: <NULL> at 0x1100, IRQ 11, 00:c0:e3:27:05:16. Aug 5 00:15:39 localhost kernel: eth0: MII transceiver #1 control 3100 status 7809. Aug 5 00:15:39 localhost kernel: eth0: Autonegotiation advertising 01e1 link partner 0000. Aug 5 00:15:39 localhost kernel: serial_attach(device 14:00.1) Aug 5 00:15:39 localhost kernel: tty01 at 0x1000 (irq = 11) is a 16550A Aug 5 00:15:38 localhost cardmgr[410]: executing: './network start eth0' Aug 5 00:15:40 localhost cardmgr[410]: executing: './serial start ttyS1' ... >cat /var/lib/pcmcia/stab Socket 0: Ositech Jack of Spades Fast Ethernet/Modem 0 network epic_cb 0 eth0 0 serial serial_cb 0 ttyS1 4 65 Socket 1: empty 4 65 Socket 1: empty >cardctl ident Socket 0: product info: "Ositech", "Trumpcard:JoS Ethernet", "400062-002", "123456789abc" manfid: 0x0140, 0x0012 function: 6 (network) Socket 1: no product info available >cardctl config Socket 0: Vcc 3.3V Vpp1 3.3V Vpp2 3.3V interface type is "cardbus" irq 11 [exclusive] [level] function 0: io 0x1000-0x11ff [32bit] function 1: io 0x1000-0x11ff [32bit] Socket 1: not configured >cardctl status Socket 0: 3.3V CardBus card function 0: [ready] function 1: [ready] Socket 1: no card >cardctl ident Socket 0: product info: "Ositech", "Trumpcard:JoS Ethernet", "400062-002", "123456789abc" manfid: 0x0140, 0x0012 function: 6 (network) Socket 1: no product info available >cardctl config Socket 0: Vcc 3.3V Vpp1 3.3V Vpp2 3.3V interface type is "cardbus" irq 11 [exclusive] [level] function 0: io 0x1000-0x11ff [32bit] function 1: io 0x1000-0x11ff [32bit] Socket 1: not configured >cardctl status Socket 0: 3.3V CardBus card function 0: [ready] function 1: [ready] Socket 1: no card >cat /proc/pci ... Bus 0, device 11, function 0: CardBus bridge: Toshiba ToPIC95 (rev 7). Slow devsel. Fast back-to-back capable. IRQ 11. Master Capable. Latency=64. Max Lat=4. Bus 0, device 11, function 1: CardBus bridge: Toshiba ToPIC95 (rev 7). Slow devsel. Fast back-to-back capable. IRQ 11. Master Capable. Latency=64. Min Gnt=128.Max Lat=4. >cat /proc/modules autofs 9604 1 (autoclean) serial_cb 1148 1 epic_cb 10440 2 cb_enabler 2536 4 [serial_cb epic_cb] ds 6444 2 [cb_enabler] i82365 22948 2 pcmcia_core 45856 0 [cb_enabler ds i82365] ... >cat /proc/interrupts CPU0 0: 234892 XT-PIC timer 1: 4248 XT-PIC keyboard 2: 0 XT-PIC cascade 8: 1 XT-PIC rtc 11: 694 XT-PIC YMF744, i82365, eth0, usb-uhci 12: 58481 XT-PIC PS/2 Mouse 13: 1 XT-PIC fpu 14: 5689 XT-PIC ide0 15: 2 XT-PIC ide1 NMI: 0 ------------------------------------------------------------------------------ |
[ Edit This Forum ]