[ Next-in-Thread ]  [ Next Message ] 

Question: Problem on Toshiba Dynabook SS6000 

Forum: PCMCIA on Toshiba laptops
Date: 1999, Nov 23
From: Barry Yip kwyip 

Hi All,

I've difficulty for the pcmcia service to initialise properly
on a Toshiba DynaBook SS6000. This model is available in
Japanese version only. I've access to quite a few other
Toshiba models and the pcmcia package works great (kudos to
developers) so far except for this particular model. 

I am using Linux 2.2.13 and PCMCIA Card Services 3.1.4. Here
is the message shows up when booting.

Intel PCIC probe:
  Toshiba ToPIC97 PCI-to-CardBus at bus 0 slot 19, mem 0x68000000, 2 sockets
    host opts[0]: [slot 0xf0] [ccr 0x10] [cdr 0x86] [rcr 0x02] [no pci irq] [lat 168/176] [bus 20/20]
    host opts[1]: [slot 0xf0] [ccr 0x20] [cdr 0x86] [rcr 0x02] [no pci irq] [lat 168/176] [bus 21/21]

At this point, the system hangs up completely.

I will appreciate if there is any work around and anything I can check.

Regards,

Barry

[ Next-in-Thread ]  [ Next Message ] 

Messages Inline: [ 0 ]  [ 1 ] 

Probably an interrupt scan failure

Re: Question: Problem on Toshiba Dynabook SS6000 (Barry Yip)
Date: 1999, Nov 23
From: David Hinds <dhinds@pcmcia.sourceforge.org> 

> 
> At this point, the system hangs up completely.

This is almost certainly an interrupt scan failure.  There is a
section in the PCMCIA-HOWTO that discusses this and suggests how to
set the PCMCIA startup options to work around it.

-- Dave
Problem on Toshiba Dynabook SS6000

[ Add Message ]  to: "Problem on Toshiba Dynabook SS6000"

[ Members ]  [ Subscribe ]  [ Admin Mode ] 
[ Show Frames ]  [ Help for HyperNews at pcmcia-cs.sourceforge.net 1.10 ]