Next-in-Thread Next Message

None WaveLan IEEE, cardmgr do not know wvlan0 interface 2 

Forum: PCMCIA Wireless Network Adapter Issues
Re: Question WaveLan IEEE, cardmgr do not know wvlan0 interface (viktor safar)
Date: 2000, May 31
From: viktor safar 4roses

Thank You Dave for fast response.

Looks like You have right. Unfortunately we can't upgrade
from kernel 2.0.x to 2.2.x, because of shaper module. (It
works not properly under 2.2.x with aliased interfaces).
And I guess that to change nettools in different kernel
versions is not very smart. There is some differences in
2.2.x ...

Yes, wavelan2_cs is realy not old, it's old only from my
viewpoint, we use it succesfully over 1 year :-). But now
we need to settle two WaveLan cards in one linux box, one
in ad-hoc and one in BSS mode. And this works with drivers
from Andreas (according technician from Lucent Prague, CZ).

On pages of Andreas stands, that his drivers should work
with kernel 2.0.x ...

I've tried, to use a eth=1 switch with wvlan_cs.o driver,
which is designed to turn off the special naming from
"wvlan0" into obvious "eth0".
The result was that the driver registers no interface !!!

The driver yells:
 wvlan_cs: WaveLAN/IEEE PCMCIA driver v1.0.4
 wvlan_cs: (c) Andreas Neuhaus <>
 wvlan_cs: index 0x01: Vcc 5.0, irq 3, io 0x0100-0x013f
 wvlan_cs: Registered netdevice
 wvlan_cs: Valid channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 
 wvlan_cs: MAC address on wvlan0 is 00 60 1d 04 05 93 
 cardmgr[47]: executing: './network start '
funny, isn't it?

I need some suggestion, how to say to linux, that wvlan0
is a valid intarface. 

thanks again

Next-in-Thread Next Message

Select this message: WaveLan IEEE, cardmgr do not know wvlan0 interface 2

Messages Inline: 1 All Outline: 1 2 All

1. None Whoops, my mistake... by David Hinds, 2000, May 31

Message Administration

This form allows you to delete, move, or copy one or more messages. You can move messages by copying and deleting the original. The action will be applied to the messages you select above and all replies to those selected messages.

If you want to copy or move messages, specify the HyperNews path of a destination forum or message that all messages will be copied or moved to. The destination must already exist, so maybe create it first.

Path of Destination (a Forum or Message): (e.g. "test")

Notify Subscribers at destination

If you want to delete messages (the default), specify that here. If you want to move messages, you need to delete the original messages; placeholders will be left pointing to where they were moved.

Delete Messages

Caution: After deleteing messages (the default), if you have not copied them (i.e. no destination above), then the selected messages are not be recoverable.

Members Subscribe No Admin Mode Show Frames Help for HyperNews at 1.10
[ Edit This Forum ]