Next-in-Thread Next Message

Question "3.1.8 can't figure out the interrupt routing"  

Forum: PCMCIA Wireless Network Adapter Issues
Re: Question lucent ieee turbo pci adapter (Bob Cohen)
Re: None 3.1.8 can't figure out the interrupt routing (David Hinds)
Date: 2000, Feb 18
From: Gerald Richter richter

I have the same problem with a lucent WaveLan IEEE and a CL 6729 PCI Controller. I can access the card, but no interrupts are coming thru. The lspci shows that

"pin A routed to IRQ 11"

but I am not able to set anything to irq 11. When I don't specify an irq, the irq of the wvlan_cs driver is set to 5 and no irq is comming thru (/proc/interrupts shows 0).

What are the correct irq that the wvlan_cs driver should use, how can I debug this problem further?

Thanks for any help

Gerald

Next-in-Thread Next Message

Messages Inline: 0 All Outline: 1 2 3

None This is a somewhat rare configuration

Re: Question "3.1.8 can't figure out the interrupt routing" (Gerald Richter)
Date: 2000, Feb 18
From: David Hinds <dhinds@pcmcia.sourceforge.org>

The current PCMCIA drivers can't handle the CL 6729 PCI card properly;
the drivers are not set up to allow use of PCI interrupts with this
bridge type.  Fixing this is in my queue of things to do, but I have
not gotten to it yet.

-- Dave
1. None RE: This is a somewhat rare configuration by Gerald Richter, 2000, Feb 18
(_ None It's true for most bridges like this by David Hinds, 2000, Feb 18
"3.1.8 can't figure out the interrupt routing"


Add Message to: ""3.1.8 can't figure out the interrupt routing" "

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10