Next-in-Thread Next Message

None Re: No interrupt routing table 

Forum: PCMCIA Wireless Network Adapter Issues
Re: Sad Lucent PCI/PCMCIA adapter + Wavelan IEEE silver (Douglas S. J. De Couto)
Re: Question same problems on single processor (Douglas S. J. De Couto)
Re: None No interrupt routing table (David Hinds)
Date: 2000, Jul 18
From: Douglas De Couto decouto

> > No PCI interrupt routing table was found.
> Well, that's bad.  That means we don't know which PCI devices are
> connected to which PCI interrupt (PIRQ) pins:
> > Interrupt router at 00:07.0: Intel 82371SB PIIX3 PCI-to-ISA bridge
> >   PIRQ1 (link 0x60): unrouted
> >   PIRQ2 (link 0x61): irq 10
> >   PIRQ3 (link 0x62): irq 11
> >   PIRQ4 (link 0x63): unrouted
> What I would do is to first try setting:
>     PCIC_OPTS="pci_irq_list=10,10"
> and see if that works.  If not, try 11,11.  If that also fails, then
> try moving the adapter to another PCI bus slot and repeat the tests.
> -- Dave

thanks for the new info.  unfortunately i have tried the card in every
pci slot, with each permutation of PCIC_OPTS="",
PCIC_OPTS="pci_irq_list=10,10", and PCIC_OPTS="pci_irq_list=11,11",
and i still get Tx timeouts from the card.

Where does the trouble lie?  Is it that the PCI/PCMICA bridge doesn't
correctly interface with PCI (because all my other devices are

thanks for your help

Douglas S. J. De Couto

Next-in-Thread Next Message

Messages Inline: 0 All Outline: 1 3 All

None Oops, I left out something important

Re: None Re: No interrupt routing table (Douglas De Couto)
Date: 2000, Jul 18
From: David Hinds <>

Oh wait.  Back up and try:

    PCIC_OPTS="irq_mode=0 pci_irq_list=10,10"


    PCIC_OPTS="irq_mode=0 pci_irq_list=11,11"

again for different slots.

-- Dave
1. None Re: Oops, I left out something important by Douglas S. J. De Couto, 2000, Jul 20
Re: No interrupt routing table

Add Message to: "Re: No interrupt routing table"

Members Subscribe Admin Mode Show Frames Help for HyperNews at 1.10