Next-in-Thread Next Message

None More info 

Forum: PCMCIA Wireless Network Adapter Issues
Re: Question Help getting Webgear Aviator 2.4 working under linux (Robert Lowery)
Date: 2000, Jul 13
From: Robert Lowery reddwarf

when I run test_network I get the following

PCMCIA network settings are coming from /etc/pcmcia/network.opts.
  /etc/sysconfig/network-scripts/ifcfg-eth0 also exists??

Checking network interface eth3 (ray_cs driver):

  Current ifconfig settings:
  eth3      Link encap:Ethernet  HWaddr FF:00:FF:48:FF:B3
            inet addr:  Bcast:  Mask:
            UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
            RX packets:0 errors:0 dropped:0 overruns:0 frame:0
            TX packets:83 errors:0 dropped:0 overruns:0 carrier:0
            collisions:0 txqueuelen:100

  The interface is configured and running.
  TX looks ok, but there seems to be an RX problem.

  You have not configured a gateway or default route.

  Enter a numeric IP address to ping:

  Pinging ... response received!
  The device interrupt does not seem to be incrementing normally.

What does this mean?

Next-in-Thread Next Message

Add Message to: "More info"

Members Subscribe Admin Mode Show Frames Help for HyperNews at 1.10