On Tue, 15 Aug 2000 09:59:48 -0700, David Hinds wrote: >That isn't the exact message, and the rest of the output would be Yeah.. I tried to wing it from memory. Should have mentioned that. Sorry. >useful, but my guess is what it means is that you are using a wireless >network card in a PCI host adapter in a desktop system and you haven't >specified the right startup options to configure the adapter to use >PCI interrupts. > >But without more context, that's just a guess. My bad... I should know better. I was in the middle messing with various PNP bios settings and didn't prepare well enough. I am using a RayLink wireless card with the adapter that came with it. But it's not PCI. That would probally work. It's an ISA PNP adapter using the Ricoh RF5C296 bridge. All appears to go without problems until I actually try to use the cards. They both start networks when one should start and one should join. (FWIW I can't get them to work under windows either) Data on Cory's page and other web sources say that this is either a card failure or some sort of receive problem where the card dosen't get any data thus it starts a new network. So far nothing in the debug level 5 output from ray_cs shows anything to be amiss. When I found the network script and it mentioned RX seeming to have a problem I started to look at my IRQs'. (I am in the middle of installing isapnptools now to see if I can find any more info) Here's the output from test_network: (more or less I am retyping) ---------- PCMCIA network settings are coming from /etc/pcmcia/network.opts Checking network itnterface eth1 (ray_cs driver) Kernel messages for eth1: eth1: RayLink, irq 5, hw_addr 00:00:8f:48:e3:03 current ifconfig setting all pretty much std.. IP: 10.0.1.1 Bcast: 10.0.1.255 mask: 255.255.255.0 zeros on all the RX, TX, etc stats: Interrupt 5 The interface is configured and running There hasn't been any traffic on this interface There is a route to a gateway at 10.0.1.1 Pinging 10.0.1.1.... response received! The device interrupt does not seem to be incrementing normally. ---------- -- Richard A. Smith Bitworks, Inc. rsmith@bitworks.com 501.846.5777 Sr. Design Engineer http://www.bitworks.com |
Messages