I have a RBEM56G-100 PCMCIA card in a DELL Inspiron 7500.
The ethernet portion works quite well. It's not perfect as I do get RX errors:
eth0 Link encap:Ethernet HWaddr 00:10:A4:C4:52:BA
inet addr:192.168.0.8 Bcast:192.168.0.255 mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:56 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Interrupt:11 Base address:0x200
The modem, on the other hand, it quite flawed. It will
connect and work fine until it decides to stop. It will only
stop on certain things - like a web page or ftp site.
When it stops, I go somewhere else and it works fine.
Example, whenever I try to download the file:
it will get about the first 30K and then stall....
but I can go to a different ftp site and get a different file
in the same session. It will ALWAYS fail on that particular
There are certain web pages that do the same thing.
Does anyone know what the problem might be? I wrote to Xircom
and they told me that they are actively working with the open
source community to develop tulip_cb.c. True?
Thanks for the help.
Oh.. I see there were no RX errors in eth0 in the message I posted... Now I'm not sure if I saw errors there or not....
This is the output from ppp0 though:
ppp0 Link encap:Point-to-Point Protocol
inet addr:184.108.40.206 P-t-P:220.127.116.11 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP PROMISC MULTICAST MTU:1500 Metric:1
RX packets:728 errors:19 dropped:0 overruns:0 frame:19
TX packets:677 errors:0 dropped:0 overruns:0 carrier:0
Thanks again everyone.
> Does anyone know what the problem might be? I wrote to Xircom
> and they told me that they are actively working with the open
> source community to develop tulip_cb.c. True?
Not to my knowledge. But since the tulip_cb (ethernet) driver is
working ok, that is not your problem. The modem is unrelated and just
uses the regular kernel serial driver.
I'm afraid I don't really know what to suggest regarding the modem
problem. Maybe it is a matter of choosing the right modem init
string. The pamphlet that came with my CBEM card doesn't have any
suggestions. But looking at the .INF file for the modem on the driver
disk, I'd try the following init string:
AT &F E0 &C1 &D2 V1 S0=0 S95=45 W2