Next-in-Thread Next Message

None Re: Note: CBEM56G 

Forum: Xircom PCMCIA Ethernet Adapter Issues
Re: Note CBEM56G (Chris Kees)
Re: None Re: Note: CBEM56G (David Hinds)
Re: None Re: Note: CBEM56G (Chris Kees)
Date: 1999, Oct 29
From: David Hinds <dhinds@pcmcia.sourceforge.org>

On Fri, Oct 29, 1999 at 03:01:23PM -0700, Chris Kees wrote:
> 
> The reason I put those calls in start_fn was because I had seen it
> suggested in the HOWTO, but everything was working fine with 3.1.0 and
> 3.1.1 just using the scripts that came with the pcmcia package.

Then in that case I'm not sure what's going on.  I don't see any
relevant changes in the 3.1.2-3.1.3 network scripts.  To diagnose, you
should verify that the network script isn't putting any errors in the
system log.  You can also run the script by hand ("/etc/pcmcia/network
start eth0", or "sh -x /etc/pcmcia/network start eth0") to see exactly
what it is doing.

> I meant to say insert here. I don't appear to be having any problems
> using cardctl insert and eject with the the current package which is why
> I thought I could just use them with apm instead of shutting down the
> whole pcmcia package with pcmcia stop.

You should be able to use insert and eject, and no, they don't do the
same thing as suspend and resume.  It might be that there are some
weird timing issues at resume time; most of my cards work correctly
across suspend/resume so I haven't experimented with setups like this.

-- Dave

Next-in-Thread Next Message

Add Message to: "Re: Note: CBEM56G"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10