Next-in-Thread Next Message

None Problem using CEM 56 with new pcmcia-cs-3.1.8 

Forum: Xircom PCMCIA Ethernet Adapter Issues
Date: 2000, Jan 11
From: TeeJin TeeJin

I m using IBM 600 with Mandrake 6.1.

Was using CEM 56s working fine until I upgraded the pcmcia package to pcmcia-cs-3.1.8

Some stack error occured while doing a cardctl config.

Network seems fine , Red LEDS running at 100 BTX, I am able to get ifconfig up but modem fails to initialise.

Tried to exclude port 2f8-2ff but no avail. Tried excluding IRQ 3 as well.

THe other thing is previously prior to using the latest pcmcia pacakge I m trying to use 2 CEM 56s to setup an ethernet bridge. The first one eth0 runs at 10 BTX (green leds) while the 2nd eth1 runs at 100 btx (red led)

cardctl config and cat /var/run/stab shows up fine.

Network is fine with the exception of the difference in the line speed.

No such problem while running on a single card.

Any resources that I should exclude or include?

Read about a bug in multifunction cards but do not know if this applies.

Appreciate any help.

TeeJin

Next-in-Thread Next Message

Messages Inline: 1 All Outline: 1 2 All

1. None Should be fixed now by David Hinds, 2000, Feb 24

Add Message to: "Problem using CEM 56 with new pcmcia-cs-3.1.8"

Members Subscribe Admin Mode Show Frames Help for HyperNews at pcmcia-cs.sourceforge.net 1.10